柜式空调进风格栅导风角度对风量及流场特性的影响研究
Research on the Influence of Air Intake Grille Guide Vane Angle on Air Volume and Flow Field Characteristics of Cabinet Air Conditioner
为解决10P下回风立柜式空调器进风压损大、蒸发器风速分布不均导致的换热效率低下问题,本文以进风格栅折边导风角度为优化变量,通过Ansys CFD数值仿真方法,对比分析30°折边与67.5°折边在相同工况下的压力损失、流场分布及风量变化规律。结果表明:优化后格栅的进风局部压损峰值降低11.3%,蒸发器横截面风速标准差从0.28m/s降至0.12m/s,背风面风速均匀性提升42.9%,系统风量提升2.5%,且风量测试误差远小于提升幅度。针对离心风机安装位置导致的出风口流场不均问题,提出风机偏移量与导风罩曲率的定量优化建议。
To address the issues of high pressure loss in the return air duct of the 10P air conditioning unit and the uneven distribution of the evaporator air velocity, which result in low heat exchange efficiency, this paper takes the folded edge deflection angle of the inlet grille as the optimization variable. Through the Ansys CFD numerical simulation method, the pressure loss, flow field distribution, and air volume variation laws of 30° folded edge and 67.5° folded edge under the same working conditions are compared and analyzed. The results show that the peak local pressure loss of the optimized grille is reduced by 11.3%, the standard deviation of the cross-sectional air velocity of the evaporator is reduced from 0.28 m/s to 0.12 m/s, the uniformity of the wind speed on the backwind side is improved by 42.9%, the system air volume is increased by 2.5%, and the air volume test error is much smaller than the increase amount. For the problem of uneven flow field at the outlet caused by the installation position of the centrifugal fan, quantitative optimization suggestions for the offset amount of the fan and the curvature of the deflector are proposed.
| [1] |
中国空调产业研究院. 2025年中国空调进风栅市场调查报告[R]. 北京: 机械工业出版社, 2025: 45-62,89- 98. |
| [2] |
刘军, 王鹏, 李丽。 空调室外机格栅百叶角度对换热性能的影响[J]. 制冷与空调, 2024, 24 (05): 34-40. |
| [3] |
杨明, 彭家驹, 骆海。 空调器定出风式外机格栅强度与风量优化[A]//2025年中国家电科技年会论文集[C]: 《家电》杂志社, 2025: 476-480. |
| [4] |
张凯, 杨兵, 刘盟。 一种导风罩及空调室内机[P]. 中国:CN219841591U, 2023-10-17. |
| [5] |
黄伟青, 郭瑞水, 练俊兵, |
| [6] |
向武, 夏凯, 曾成, |
| [7] |
张恒庆. 基于CFD的空调风扇风道系统结构优化研究[D]. 青岛: 青岛大学, 2023. |
| [8] |
杨世铭, 陶文铨。 传热学[M].5版。 北京: 高等教育出版社, 2019: 200-220,250- 270. |
| [9] |
何雅玲。 工程热力学[M].4版。 北京: 高等教育出版社, 2018: 140-160,180- 200. |
| [10] |
张朝晖. ANSYS CFD 理论与应用[M].3版。 北京: 电子工业出版社, 2021: 115-145,200- 225. |
| [11] |
李敏, 王建华。 空调换热器CFD仿真与优化设计[M]. 北京: 机械工业出版社, 2022: 78-95,120- 136. |
| [12] |
陈焕新, 李瑛。 制冷空调系统仿真与优化[M]. 北京: 科学出版社, 2023: 89-105,150- 165. |
| [13] |
黄虎, 李志浩。 制冷空调换热器设计与应用[M]. 北京: 化学工业出版社, 2020: 65-82,109- 125. |
/
| 〈 |
|
〉 |