铜冶炼余热锅炉高效换热及颗粒回收机制

于志伟 ,  曲俊月 ,  王纪兴 ,  杨承璐 ,  周卫辛 ,  胡杰 ,  杨世亮

矿冶 ›› 2026, Vol. 35 ›› Issue (2) : 301 -312.

PDF (32317KB)
矿冶 ›› 2026, Vol. 35 ›› Issue (2) : 301 -312. DOI: 10.3969/j.issn.1005-7854.2026.02.016
双碳专栏

铜冶炼余热锅炉高效换热及颗粒回收机制

作者信息 +

Efficient heat exchange and dust recovery mechanisms for copper smelting waste heat boiler

Author information +
文章历史 +
PDF (33092K)

摘要

余热锅炉是铜火法冶炼高温烟气余热回收的关键装备,但其炉内高温环境与复杂气固两相流动显著增加了烟气-烟尘体系动力学与热力学耦合机理的解析难度。本研究采用多相粒子单元法对工业余热锅炉内的气固流动与传热行为进行数值模拟,在验证模型可靠性后,对凝渣管屏结构进行了优化设计,以提升炉内换热效率与粉尘回收率。研究结果表明:下降烟道内的涡旋流动及灰斗区域明显的烟气旁路现象是削弱气固传热效能的主因,导致锅炉排烟温度高达636 K。此外,颗粒与换热管束间的有效碰撞概率较低,限制了气固分离效率,初始颗粒沉降率仅为41.07%。通过优化,将凝渣管屏增至3组,流场分布得到显著改善,换热管屏入口及锅炉出口烟气温度分别降低了70 K和30 K,颗粒沉降率提升了6.98%。进一步研究发现,将凝渣管屏管间距扩大至400 mm可促进烟气与管束的充分接触,更有利于强化换热。本研究成果可为铜冶炼余热锅炉的结构优化设计与运行调控提供理论支撑与工程参考。

Abstract

Waste heat boiler (WHB) is the core equipment for recovering waste heat from high-temperature flue gas in the copper pyrometallurgical process. However, the strongly coupled high-temperature environment and complex gas-solid two-phase flow within WHB significantly increase the difficulty of elucidating the coupled mechanisms governing the gas-dust system. In this study, the Multiphase Particle-in-Cell (MP-PIC) method was employed to numerically simulate the gas-solid flow and heat transfer behavior within an industrial WHB. After verifying the reliability of the model, the structure of the slag-screen tube banks was optimized to improve heat exchange efficiency and dust recovery rates. The results indicate that vortex flow in the radiation section and a pronounced gas bypassing phenomenon in the hopper area are the primary factors weakening gas-solid heat transfer performance, resulting in a boiler exhaust temperature as high as 636 K. Furthermore, the low probability of effective collision between particles and heat exchange tubes limits gas-solid separation efficiency, with an initial particle sedimentation rate of only 41.07%. By increasing the number of slag-screen tube banks to three, the flow field distribution was significantly improved. This optimization led to a temperature reduction of 70 K at the inlet of the heat exchange section and 30 K at the boiler outlet, while the particle sedimentation rate increased by 6.98%. Further investigation revealed that expanding the tube pitch to 400 mm promotes sufficient contact between the flue gas and the tube bundles, which is more conducive to enhancing heat transfer. The findings of this study provide theoretical support and engineering references for the structural optimization and operational control of waste heat boilers in copper smelting.

关键词

余热锅炉 / 气固流动 / 烟气换热 / 颗粒沉降 / 数值模拟

Key words

waste heat boiler / gas-solid flow / flue gas heat exchange / particle deposition / numerical simulation

引用本文

引用格式 ▾
于志伟,曲俊月,王纪兴,杨承璐,周卫辛,胡杰,杨世亮. 铜冶炼余热锅炉高效换热及颗粒回收机制[J]. 矿冶, 2026, 35(2): 301-312 DOI:10.3969/j.issn.1005-7854.2026.02.016

登录浏览全文

4963

注册一个新账户 忘记密码

参考文献

[1]

ARDEH A Z, FATHI S, ASHTIANI F Z, et al. Kinetic modeling of a Claus reaction furnace and waste heat boiler: effects of H2S/CO2 and H2S/H2O ratio on the production of hazardous gases in an industrial sulfur recovery unit[J]. Separation and Purification Technology, 2024, 338: 126173.

[2]

史彦辉, 武海军, 杨国强, 等. 粒化-气基直接还原回收铜渣余热和有价金属[J]. 矿冶, 2023, 32(1): 83-87.

[3]

SHI Y H, WU H J, YANG G Q, et al. Recovery of residual heat and valuable metals from copper slag by granulation and gas-based direct reduction[J]. Mining and Metallurgy, 2023, 32(1): 83-87.

[4]

杨国强, 刘硕, 史彦辉, 等. 高温铜渣余热回收技术研究进展[J]. 矿冶, 2023, 32(1): 77-82.

[5]

YANG G Q, LIU S, SHI Y H, et al. Research progress of waste heat recovery technology of high temperature copper slag[J]. Mining and Metallurgy, 2023, 32(1): 77-82.

[6]

MEN Y, LIU X, ZHANG T. A review of boiler waste heat recovery technologies in the medium-low temperature range[J]. Energy, 2021, 237: 121560.

[7]

WANG T, LIU X, ZHANG Y, et al. Thermodynamic and emission characteristics of a hydrogen-enriched natural gas-fired boiler integrated with external flue gas recirculation and waste heat recovery[J]. Applied Energy, 2024, 358: 122614.

[8]

王一丰, 翟春华, 黄庆, 等. 大功率燃气轮机联合循环机组三压再热余热锅炉建模及变负荷运行规律研[J]. 热力发电, 2023, 52(1): 79-89.

[9]

WANG Y F, ZHAI C H, HUANG Q, et al. Modeling and variable load operation analysis of triple-pressure reheat heat recovery steam generator for high-power gas turbine combined-cycle units[J]. Thermal Power Generation, 2023, 52(1): 79-89.

[10]

刘博, 李辉, 李娜, 等. 余热锅炉对流受热面积灰特性的实验研究[J]. 工程热物理学报, 2013, 34(2): 290-293.

[11]

LIU B, LI H, LI N, et al. Experimental study on ash deposition characteristics of convective heating surfaces in waste heat boiler[J]. Journal of Engineering Thermophysics, 2013, 34(2): 290-293.

[12]

DING Q, TANG X, YANG Z. Failure analysis on abnormal corrosion of economizer tubes in a waste heat boiler[J]. Engineering Failure Analysis, 2017, 73: 129-138.

[13]

阳自霖, 闫友, 陈坤, 等. 铅冶炼富氧侧吹炉余热锅炉积灰结焦分析及预防[J]. 绿色矿冶, 2023, 39(2): 53-57.

[14]

YANG Z L, YAN Y, CHEN K, et al. Analysis and prevention of ash deposition and coking in waste heat boiler of oxygen-enriched side-blown furnace in lead smelting[J]. Sustainable Mining and Metallurgy, 2023, 39(2): 53-57.

[15]

KHAN H, LEHNIGK R, RZEHAK R. Euler-Euler simulation of absorption and desorption in co-and counter-current bubble column flows[J]. Chemical Engineering Science, 2023, 267: 118313.

[16]

WANG S, LUO K, HU C, et al. CFD-DEM study of the effect of cyclone arrangements on the gas-solid flow dynamics in the full-loop circulating fluidized bed[J]. Chemical Engineering Science, 2017, 172: 199-215.

[17]

ANDREWS M J, O'ROURKE P J. The multiphase particle-in-cell (MP-PIC) method for dense particulate flows[J]. International Journal of Multiphase Flow, 1996, 22(2): 379-402.

[18]

郭晨, 李慧梅, 董辉, 等. CCPP余热锅炉入口烟道烟气流动的数值模拟研究[J]. 热能动力工程, 2022, 37(10): 93-100.

[19]

GUO C, LI H M, DONG H, et al. Numerical simulation study on flue gas flow in inlet duct of CCPP waste heat boiler[J]. Journal of Engineering for Thermal Energy and Power, 2022, 37(10): 93-100.

[20]

穆林, 赵亮, 尹洪超. 废液焚烧余热锅炉内气固两相流动与飞灰沉积的数值模拟[J]. 中国电机工程学报, 2012, 32(32): 30-37.

[21]

MU L, ZHAO L, YIN H C. Numerical simulation of gas-solid two-phase flow and fly ash deposition in waste liquid incineration heat recovery boiler[J]. Proceedings of the CSEE, 2012, 32(32): 30-37.

[22]

王风录, 虞斌, 吕林, 等. 新型余热锅炉冷却水流动及传热特性模拟和优化[J]. 石油化工设备, 2023, 52(1): 16-22.

[23]

WANG F L, YU B, LYU L, et al. Simulation and optimization of cooling water flow and heat transfer characteristics in a novel waste heat boiler[J]. Petrochemical Equipment, 2023, 52(1): 16-22.

[24]

DANIS M E, DURBIN P. Hybrid RANS/LES modeling of hypersonic turbulent boundary layers with cold walls[J]. International Journal of Heat and Fluid Flow, 2024, 107: 109334.

[25]

HU J, YANG S, WANG H, et al. Flue gas-dust two-phase heat transfer characteristics and corrosion behavior in industrial-scale waste heat boilers[J]. Energy, 2024, 308: 132830.

[26]

WANG W, LI J. Simulation of gas-solid two-phase flow by a multi-scale CFD approach of the EMMS model to the sub-grid level[J]. Chemical Engineering Science, 2007, 62(1): 208-231.

[27]

YANG N, WANG W, GE W, et al. CFD simulation of concurrent-up gas-solid flow in circulating fluidized beds with structure-dependent drag coefficient[J]. Chemical Engineering Journal, 2003, 96(1): 71-80.

基金资助

有色冶炼余热锅炉结渣机制及结构优化研究(KKF0202552041)

AI Summary AI Mindmap
PDF (32317KB)

0

访问

0

被引

详细

导航
相关文章

AI思维导图

/

〈 〉