电动汽车无线充电系统的悬浮电位抑制策略

祝丽花, 赵帅, 李元, 田忠莹

天津工业大学学报 ›› 2026, Vol. 45 ›› Issue (4) : 73 -79.

PDF (2457KB)
天津工业大学学报 ›› 2026, Vol. 45 ›› Issue (4) : 73 -79. DOI: 10.3969/j.issn.1671-024x.2026.04.009
电气工程

电动汽车无线充电系统的悬浮电位抑制策略

    祝丽花1,2, 赵帅1, 李元1, 田忠莹1
作者信息 +

Floating potential suppression strategy for wireless charging system of electric vehicles

    Zhu Lihua1,2, Zhao Shuai1, Li Yuan1, Tian Zhongying1
Author information +
文章历史 +
PDF (2515K)

摘要

为提升电动汽车无线充电系统的安全性,提出了电屏蔽层悬浮电位的抑制策略。通过分析屏蔽结构和耦合电路,推导了电屏蔽层悬浮电位的约束方程,并且使用场路耦合方法对悬浮电位进行数值计算;在高频逆变器的整流部分增加共模滤波器,逆变环节使用双极性脉冲信号调制方法,以减弱高频逆变电源输出的共模分量,同时耦合线圈采用双层布线的方式;搭建85 kHz电动汽车无线充电系统,使用前端差分浮地测量技术提取电屏蔽层的悬浮电位,验证本文方法的有效性。结果表明:采用本文方法后,传输12.9 kW功率时电屏蔽层悬浮电位的峰值从1 041.10 V削弱到了65.25 V,并且在模拟人体触电实验中触电电流降低到0.91 mA,达到人体无感电流的标准。

Abstract

In order to improve the safety of the wireless charging system for electric vehicles (EV-WCS), the floating potential (FP) suppression strategy for the electric shielding is proposed. By analyzing the shielding structure and coupling circuits, the constraint equations for the FP of the electrical shielding layer are derived, and it is numerically calculated using the field-circuit coupling method. A common-mode filter is added to the rectifier section of a high-frequency inverter, and a bipolar pulse signal modulation method is used in the inverter section to effectively attenuate the common-mode component output by a high-frequency inverter power supply. Meanwhile, the coupling coils are wired in double layers. An 85 kHz EV-WCS is built, the FP of the electric shield is extracted using a front-end differential floating ground measurement technique to verify the effectiveness of the proposed method. The experimental results show that after adopting the proposed method, the peak floating potential of the electric shielding layer drops from 1 041.10 V to 65.25 V under a transmission power of 12.9 kW, and the electrocution current reduces to 0.91 mA in simulated human electrocution experiments, which reaches the standard of non-inductive current of human body.

关键词

电动汽车 / 变流器 / 无线充电系统 / 悬浮电位

Key words

electric vehicles / converter / wireless charging system / floating potential

引用本文

引用格式 ▾
祝丽花, 赵帅, 李元, 田忠莹. 电动汽车无线充电系统的悬浮电位抑制策略[J]. 天津工业大学学报, 2026, 45(4): 73-79 DOI:10.3969/j.issn.1671-024x.2026.04.009

登录浏览全文

4963

注册一个新账户 忘记密码

参考文献

[1] Wen F, Li Q, Liu L, et al.Research on harmonic influence of electric vehicle wireless charging system on power grid[C]//2019 IEEE Innovative Smart Grid Technologies-Asia (ISGT Asia). Chengdu: IEEE, 2019: 4128-4131.
[2] Jog P, Shete S, Kumawat R K, et al.Electric vehicle charging station infrastructure: A review[C]//2021 6th IEEE International Conference on Recent Advances and Innovations in Engineering (ICRAIE). Kedah: IEEE, 2021: 1-7.
[3] Elmeligy A O, Elghanam E, Hassan M S, et al.Optimal planning of dynamic wireless charging infrastructure for electric vehicles[J]. IEEE Access, 2024, 12: 30661-30673.
[4] Zhang Kehan, Zheng Biao, Luo Na, et al.Eddy loss analysis and parameter optimization of the WPT system in seawater[J]. Journal of Power Electronics, 2018, 18(3): 778-788.
[5] Mohammad M, Wodajo E T, Choi S, et al.Modeling and design of passive shield to limit EMF emission and to minimize shield loss in unipolar wireless charging system for EV[J]. IEEE Transactions on Power Electronics, 2019, 34(12): 12235-12245.
[6] Campi T, Cruciani S, Maradei F, et al.Magnetic field mitigation by multicoil active shielding in electric vehicles equipped with wireless power charging system[J]. IEEE Transactions on Electromagnetic Compatibility, 2020, 62(4): 1398-1405.
[7] Son S, Woo S, Kim H, et al.Shielding sensor coil to reduce the leakage magnetic field and detect the receiver position in wireless power transfer system for electric vehicle[J]. Energies, 2022, 15(7): 2493.
[8] Kim H, Cho J, Ahn S, et al.Suppression of leakage magnetic field from a wireless power transfer system using ferrimagnetic material and metallic shielding[C]//2012 IEEE International Symposium on Electromagnetic Compatibility. Pittsburgh: IEEE, 2012: 640-645.
[9] Wang K, Zuo Z P, Sang L, et al.Comprehensive analysis for electromagnetic shielding method based on mesh aluminium plate for electric vehicle wireless charging systems[J]. Energies, 2022, 15(4): 1546.
[10] Shen Z, Wang H, Shen Y F, et al.An improved stray capacitance model for inductors[J]. IEEE Transactions on Power Electronics, 2019, 34(11): 11153-11170.
[11] Bubert A, Zhang J K, De Doncker R W. Modeling and measurement of capacitive and inductive bearing current in electrical machines[C]//2017 Brazilian Power Electronics Conference (COBEP), 2017: 1-6.
[12] SAE Technical Standards Board. Wireless power transfer for light-duty plug-in/electric vehicles and alignment methodology: SAE TIR J2954[S]. USA: SAE International, 2019.
[13] GB/T 38775.1—2020 电动汽车无线充电系统第1部分: 通用要求[S].
GB/T 38775.1-2020 Electric vehicle wireless power transfer—Part 1: General requirements[S](in Chinese).
[14] Deng Q J, Sun P, Hu W S, et al.Modular parallel multi-inverter system for high-power inductive power transfer[J]. IEEE Transactions on Power Electronics, 2019, 34(10): 9422-9434.
[15] Lee E S, Sohn Y H, Choi B G, et al.A modularized IPT with magnetic shielding for a wide-range ubiquitous wi-power zone[J]. IEEE Transactions on Power Electronics, 2018, 33(11): 9669-9690.
[16] Li S Z, Ma T Y.Systematic analysis of advanced wireless charging technology for electric vehicles[J]. Journal of Physics: Conference Series, 2023, 2649(1): 012029.
[17] 秦润杰, 张清鹏, 卢秋朋. 多导体传输线电容电感矩阵的分析求解[J]. 电子测量技术, 2015, 38(6): 34-36.
Qin Runjie, Zhang Qingpeng, Lu Qiupeng.Analysis and solution of capacitance and inductance matrix of multi-conductor transmission line[J]. Electronic Measurement Technology, 2015, 38(6): 34-36(in Chinese).
[18] Hou J, Chen Q H, Wong S C, et al.Analysis and control of series/series-parallel compensated resonant converter for contactless power transfer[J]. IEEE Journal of Emerging and Selected Topics in Power Electronics, 2015, 3(1): 124-136.
[19] Li H C, Wang K P, Fang J Y, et al.Pulse density modulated ZVS full-bridge converters for wireless power transfer systems[J]. IEEE Transactions on Power Electronics, 2019, 34(1): 369-377.
[20] Qu X H, Han H D, Wong S C, et al.Hybrid IPT topologies with constant current or constant voltage output for battery charging applications[J]. IEEE Transactions on Power Electronics, 2015, 30(11): 6329-6337.
[21] 陶壮意, 许建平, 陈强, 等. 共模滤波器对三相Buck整流器的影响[J]. 电工技术, 2020, 47(14): 63-66,77.
Tao Zhuangyi, Xu Jianping, Chen Qiang, et al.Influencing of common mode filter on three phase Buck rectifier[J]. Electric Engineering, 2020, 47(14): 63-66,77(in Chinese).
[22] Arai N, Okamoto K, Kato J, et al.Method of measuring conducted noise voltage with a floating measurement system to ground[J]. IEICE Transactions on Communications, 2020, 103(9): 903-910.

基金资助

国家自然科学基金面上项目(52277016); 国家自然科学基金优秀青年科学基金项目(52122701)

AI Summary AI Mindmap
PDF (2457KB)

0

访问

0

被引

详细

导航
相关文章

AI思维导图

/

〈 〉