隧内结构施作时机对大直径盾构隧道横向力学性能影响研究
戴志成 , 李春林 , 张亮亮 , 李佳林
隧道与地下工程灾害防治 ›› 2026, Vol. 8 ›› Issue (3) : 122 -134.
隧内结构施作时机对大直径盾构隧道横向力学性能影响研究
Study on the effect of internal structure construction time on the transverse mechanical properties of large diameter shield tunnel
为明确隧内结构施作时机对大直径盾构隧道横向力学性能的影响,以济南黄河隧道为工程背景,建立管片-隧内结构三维实体有限元模型,以管片椭圆度表征隧内结构施作时机,设置管片椭圆度达到 3.5‰、4.0‰、4.5‰和 5.0‰时施作隧内结构的 4 种工况,对管片、隧内结构及螺栓的变形与受力特征进行对比分析。结果表明:隧内结构施作越早,管片衬砌的变形量和 Mises 应力越小,管片结构安全性越高;隧内结构过早施作会使其自身分担更多荷载,使车道板变形增大;隧内结构施作越早,螺栓应力分布越均匀且整体应力水平越低;隧内结构对管片环的约束作用在拱腰位置发挥了更大的作用,不同施作时机时管片环拱腰位置变形量基本不变。
This study was conducted to clarify the effect of the construction timing of the internal structure on the transverse mechanical performance of large-diameter shield tunnels. A three-dimensional solid finite element model of the segmental lining and internal structure was established based on the Jinan Yellow River Tunnel. The ellipticity of the segmental lining was used to characterize the construction timing of the internal structure, and four cases were considered in which the internal structure was constructed when the segmental ellipticity reached 3.5‰, 4.0‰, 4.5‰, and 5.0‰. The deformation and mechanical responses of the segments, internal structure, and bolts were compared. The results showed that less deformation and lower von Mises stress were observed in the segmental lining when the internal structure was constructed earlier, and the structural safety was thereby improved. When the internal structure was constructed too early, a larger portion of the load was carried by the internal structure, and greater deformation of the carriageway slab was produced. When the internal structure was constructed earlier, a more uniform distribution of bolt stress was obtained, and the level of bolt stress was reduced. The restraining effect of the internal structure on the segment ring was most pronounced at the arch waist; the deformation at the arch waist of the segment ring remained essentially unchanged regardless of the construction timing.
| [1] |
何川, 封坤, 方勇. 盾构法修建地铁隧道的技术现状与展望[J]. 西南交通大学学报, 2015, 50(1): 97-109. |
| [2] |
|
| [3] |
李璋, 白森, 郑建国, |
| [4] |
|
| [5] |
丁建奇, 王陈成, 朱向闪, |
| [6] |
|
| [7] |
孙文昊, 封坤, 肖明清, |
| [8] |
|
| [9] |
刘念, 李一伦. 盾构隧道双层车道结构与管片不同连接形式的受力分析[J]. 城市道桥与防洪, 2020(1): 201-203. |
| [10] |
|
| [11] |
温竹茵, 刘念, 燕晓. 盾构隧道双层车道结构与管片不同连接形式研究[J]. 现代隧道技术, 2020, 57(增刊 1): 382-386. |
| [12] |
|
| [13] |
崔佳, 张力, 郭文琦. 盾构隧道装配式内部结构形式及其对管片受力的影响[J]. 建筑技术开发, 2021, 48(15): 96-98. |
| [14] |
|
| [15] |
王均勇, 封坤, 孙文昊, |
| [16] |
|
| [17] |
潘文韬, 肖明清, 封坤, |
| [18] |
|
| [19] |
薛光桥, 肖明清, 封坤, |
| [20] |
|
| [21] |
禹海涛, 李龙津, 曹春艳, |
| [22] |
|
| [23] |
徐秀峰, 黄爱军. 地面卸载作用下软土大直径轨道交通盾构隧道结构变形预测[J]. 中国市政工程, 2016(5): 62-66. |
| [24] |
|
| [25] |
王程, 汤鹏, 庄海洋, |
| [26] |
|
| [27] |
王明年, 胡萧越, 唐雄俊, |
| [28] |
|
| [29] |
何应道, 肖明清, 封坤, |
| [30] |
|
| [31] |
王伟, 刘英, 庄海洋, |
| [32] |
|
| [33] |
杨文波, 杨林霖, 梁杨, |
| [34] |
|
| [35] |
|
| [36] |
李春林, 张西文, 刘广森, |
| [37] |
|
| [38] |
朱伟东. 大直径盾构隧道装配式内部结构施工期变形特性研究[D]. 济南:济南大学, 2022: 37-72. |
| [39] |
|
| [40] |
陈孝华, 何应道, 封坤, |
| [41] |
|
| [42] |
黎晨, 张开银, 黄俊. 盾构隧道内部双层车道板结构受力分析[J]. 现代隧道技术, 2016, 53(1): 103-110. |
| [43] |
|
| [44] |
赵延喜, 宗兰. 基于有限元的盾构隧道内部结构承载能力评价[J]. 江苏建筑, 2018(6): 46-48. |
| [45] |
|
| [46] |
鲁选一, 封坤, 漆美霖, |
| [47] |
|
| [48] |
张亮亮, 张西文, 孙文昊, |
| [49] |
|
| [50] |
|
| [51] |
|
| [52] |
|
| [53] |
|
| [54] |
T/ CHTS 10268- 2025 公路水下大直径盾构隧道技术规范[S]. |
| [55] |
GB 50010- 2010 混凝土结构设计规范[S]. |
| [56] |
GB 50017-2017 钢结构设计标准[S]. |
| [57] |
GB 1499.2-2024 钢筋混凝土用钢第 2 部分:热轧带肋钢筋[S]. |
| [58] |
陈富强, 田唯, 刘占国, |
| [59] |
|
| [60] |
许宏发, 吴华杰, 郭少平, |
| [61] |
|
| [62] |
王士民, 于清洋, 彭博, |
| [63] |
|
| [64] |
GB 50446-2017 盾构法隧道施工与验收规范[S]. |
济南城市建设集团有限公司科技开发计划资助项目(2020W003)
中铁第四勘察设计院集团有限公司科技研究资助项目(TSYSDY-JLLCHSD[2020]-01, 2024-A01)
/
| 〈 |
|
〉 |