CSM-KA 型信号集中监测系统无效报警成因分析与优化策略
Analysis on Causes of Invalid Alarms and Optimization Strategies of CSM-KA Centralized Signal Monitoring System
铁路信号集中监测系统是保障行车安全、提升运维效率的核心基础设施,但现场应用中无效报警占比偏高,严重干扰故障研判并大幅增加运维负荷.本文以青藏铁路 CSM-KA 型监测系统为研究对象,结合现场运维数据,系统梳理出报警阈值适配性不足、开关量与模拟量采集时序不同步、天窗修管理不规范及报警机制存在局限性四大核心成因.从阈值动态优化、采集机制改造、天窗修全流程管控、智能报警级联四个维度提出一体化优化策略.现场应用结果表明,该方案可有效降低无效报警占比,减少现场运维工作量,提升故障报警分析处置效率.
The railway centralized signal monitoring system is the core infrastructure for ensuring traffic safety and improving operation and maintenance(O&M) efficiency. However, the proportion of invalid alarms in field application is relatively high, which seriously interferes with fault diagnosis and greatly increases the O&M load. Taking the CSM-KA monitoring system of the Qinghai-Tibet Railway as the research object and combining with field O&M data, this paper systematically sorts out four core causes: insufficient adaptability of alarm thresholds, unsynchronized acquisition timing of switching values and analog values, non-standard skylight maintenance management, and limitations of the alarm mechanism. An integrated optimization strategy is proposed from four dimensions: dynamic threshold optimization, acquisition mechanism transformation, whole-process control of skylight maintenance, and intelligent alarm cascade. Field application results show that the scheme can effectively reduce the proportion of invalid alarms and on-site O&M workload, and improve the efficiency of fault alarm analysis and handling.
| [1] |
国家铁路局. 铁路信号集中监测系统技术条件: Q/CR 442-2020[S]. 北京: 中国铁道出版社有限公司, 2020. |
| [2] |
刘贺军, 胡亚峰. 铁路信号集中监测系统研究与应用现状[J]. 铁路通信信号工程技术, 2020, 17(6): 78-81. |
| [3] |
王雪鹏. 利用信号集中监测数据分析ZPW-2000A轨道电路故障方法[J]. 现代交通技术研究, 2024, 7(2): 12-15. |
| [4] |
吴卉. 道岔动作电流曲线在转辙机故障诊断中的应用[J]. 铁路计算机应用, 2024, 33(3): 67-71. |
| [5] |
杨世武. 信号集中监测系统冗余报警过滤优化方案[J]. 铁道通信信号, 2022, 58(5): 36-39. |
| [6] |
傅荟瑾. 基于智能算法的铁路信号监测异常报警优化研究[J]. 铁道标准设计, 2023, 67(9): 142-146. |
/
| 〈 |
|
〉 |